70.2.2 Command Description (Dialog Input)

70.2.2 Command Description (Dialog Input)

When entering DEBUG commands, the following points should be noted:

Immediately after starting the AMO, the user receives a DEBUG output which shows the DEBUG status.:


Status: "*" DEBUG is in command request mode
"**" DEBUG is in comment mode

There then follows the following output, which shows the user that an input is requested:

DEBUG INPUT FOR <processor name> PLEASE :
*

This AMO output is simultaneously an indication that the previously entered DEBUG command was processed by Hicom DEBUG.

When this promt appears, the user may enter the desired DEBUG command string (see parameter CMDSYS).

Start AMO DEBUG.

*
DEBUG INPUT FOR BPA PLEASE :
The following four commands are input in order to output a memory area using the Hicom DEBUG. The debug input should be sent to the Hicom DEBUG in processor BPA (= SWU). Because the input is mainly DEBUG texts, please refer to the User Manual for Hicom DEBUG for explanations.

Hicom DEBUG indicates that it is in the command mode by outputting an asterisk "*", and that it is in the statement mode by outputting a double asterisk "**".

304I START :DEBUG V2.3 KV2: SESSION STARTED AT:
19:12:48 20/10/1986
*
DEBUG INPUT FOR BPA PLEASE:

Entry into Direct Dialog with Hicom DEBUG

**
DEBUG INPUT FOR BPA PLEASE :

Output a Memory Area;

*"TRACE C:1:123:456 (10);!"

0615T TRACE :TRACE INSTRUCTION EXECUTED
01:0123:0456 = 50 8E 46 06 B8 00 00 06 50 E8 17 E7 E9 3D 01 8E
**
DEBUG INPUT FOR BPA PLEASE :

Terminate the Input

*
DEBUG INPUT FOR BPA PLEASE :

Terminate the Hicom DEBUG

AMO-DEBUG -... ACCESS TO THE SYSTEM DEBUG FACILITY
EXEC COMPLETED;

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.