90.3.9 START-FAMUP

An UPDATE is started manually by sending a SAVE job to the incoming mailbox of the logical device unit (LDU) FAMUP. All changes made by this time to the static database, the APS directory and the PATCH directory are transmitted to the service center SZ. FAMUP and FTRNS must be active. When the SAVE job is sent, the AMO FAMUP outputs a message.
By declaring the parameter INIT=Y, the UPDATE function is initialized. All the information stored up to this point in time is deleted, together with the data transfer version numbers. Version numbers for the transfer of database updates are then counted from 1 again. The initialization must be started immediately after the generation of the MMLCMD command batch (initial generating batch), which is then stored in the HTS. The first transfer should not take place until the generating patch has been accepted.

Procedure Overview


Command Code	Parameter
START-FAMUP	[INIT=N];

	\|[INIT=Y],[INS=<param>];

Example

Starting an UPDATE manually

Input:

STA-FAMUP:Y,Y;

Output:

START-FAMUP:Y,Y;
H500: AMO FAMUP STARTED
SAVE JOB SENT TO LDU FAMUP 87-12-31 23:59:59
AMO-FAMUP -... REMOTE ADMINISTRATION & MAINTENANCE UPDATE
START COMPLETED

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.