101 FUNCT - System switches

This AMO is used to actuate the switches with which the following functions are deactivated or activated:
•
No display of command echoing, the end message and the echoing of headers
•
the language of AMO-calls
•
switches of routine test organisation in some parts of ISp (Administration, TFS and VMS)
•
splitting of CC (Common Control)
•
new loading of subsystem UBGDAT (data of ports), when the SIT (signalisation task) uses this data.
Also it is possible to setup a time, in which the XENIX server has to be active, if the IHS is out of service (XENIX retention time).
If an externally attached power supply is present, it can also be configured depending on it’s type (e.g. AC/DC Without redundancy).
Besides it is possible to configure the type of SS7 controller attached to the switch : Telephone user part controller / ISDN user part controller / no controller attached.
Futher it is possible to set a session specific AMO Text Language (German or English).
It is even possible to control the REGEN output using three new switches.
In addition, it is possible to display and regenerate the current switch settings.
It is possible to switch off logging of certain AMOs.
The user interface for the AMO-FUNCT is in English. Text output for the AMOs is also in English, even if the system is set to operate in a different language.
${DocTitle}, ID: ${DocID}
 © 02/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
 All other trademarks herein are the property of their respective owners.