125.6 Error messages and advisories

125.6.1 Error messages


F01:	CONNECTIONS FROM <aaa> TO <bbb> IN LEVEL <c> CANNOT BE DENIED SINCE THE MEMORY AREA WHICH WAS ASSIGNED BY MEANS OF THE AMO DIMSU PARAMETER RSTCON HAS ALREADY BEEN USED UP.
F02:	STATION NUMBER MODIFICATIONS FROM NODE <ddddd> TO NODE <eeeee> IN LEVEL <c> CANNOT BE ENTERED SINCE THE MEMORY AREA WHICH WAS ASSIGNED BY MEANS OF THE AMO DIMSU (PARAMETER DSPMOD AND DPDSPMOD) HAS ALREADY BEEN USED UP.
F03:	MODCON = NOMOD MUST NOT BE CONCATENATED WITH OTHER VALUES.
F04:	FOR CHANGING A MODIFICATION VALUE (MODCON, NUMEXT, NUMRED), NPI IS MANDATORY.
F05:	LOGICAL NODES (PARAMETER ONNOL, DNNOL) ARE NOT ALLOWED FOR DENYING CONNECTIONS.
F06:	<fffff> = <ggg> IS OUT OF RANGE FOR LEVEL = <c>. POSSIBLE RANGE: 1 - <hhh>
F08:	<fffff> IS ONLY VALID FOR A SPECIFIC LEVEL.
F09:	TOO MANY ENTRIES FOR DENIED CONNECTIONS OR MODIFICATIONS: THE MAXIMUM RUNTIME WAS EXCEEDED. THE ENTRIES UNTIL NODE <ddddd> OF LEVEL <c> HAVE BEEN EXECUTED. PLEASE ENTER COMMAND AGAIN FOR THE REMAINING NODES.
F10:	THE LOGICAL NODE ’OWN’ IS ONLY ALLOWED FOR NPI=UNKNOWN AND LEVEL=0
F11:	THE SPECIAL VALUE ##### IN PARAMETER NUMEXT/NUMRED IS ONLY ALLOWED FOR THE LOGICAL NODE ’OWN’. EITHER ONNOL OR DNNOL MUST BE ’OWN’.
F12:	OWN NODE ID’S COULD NOT BE PICKED UP FROM KNDEF-TABLE BECAUSE NODE ID <ggg> IS NOT UNIQUE IN LEVEL 0 IN KNDEF-TABLE.
F13:	OWN NODE ID’S COULD NOT BE PICKED UP FROM KNDEF-TABLE BECAUSE THE KNDEF-TABLE FOR OWN NODES IS EMPTY.
F14:	OWN NODE CODES COULD NOT BE EXTRACTED FROM KNDEF-TABLE (NO ENTRY IN KNDEF FOR NODECD OR NODECDSK).
F15:	MODCON IS ONLY VALID IN COMBINATION WITH NUMBER EXTENSION OR REDUCTION. MODCON WAS IGNORED BECAUSE NO NUMBER EXTENSION OR REDUCTION WAS FOUND EITHER IN COMMAND OR IN MODIFICATION MATRIX.
F16:	ONNOL AND DNNOL MUST NOT BE BOTH ’OWN’ IF NODE CODES ARE TO BE EXTRACTED FROM KNDEF-TABLE (NUMEXT/NUMRED=#####).

Output texts:


<aaa>:	Originating node / region number
<bbb>:	Destination node / region number
<c>:	Level
<ddddd>:	Originating node / region number or OWN, ROW or CDR
<eeeee>:	Destination node / region number or OWN, ROW or CDR
<fffff>:	Parameter ONNO or DNNO
<ggg>:	Node / region number
<hhh>:	Highest permissible node / region number

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.