128.2.4
EXEC-LANC
This command initiates the dynamic loading of all WAML configuration data during operation. The board is also loaded:
•
When added by means of AMO BCSU,
•
When inserted in the LTU shelf,
•
When activated by means of AMO BSSU.
The WAML does not use the configured data until it has been successfully loaded.
The response message from PIT is timer supervised, a timer is set for this purpose.
If the board data can not be loaded or it doesn’t succeed, an error message with possible remedy is output and the AMO stops. An unsuccessful loading can have the following reasons:
–
board data have not been configured yet
–
WAML board is not available
–
no acknowledge has arrived from PIT within the 10 minutes response time
–
the dynamic board identifier is not available
–
board is not in state ’ready’.
Procedure overview
Command code
Parameter
EXEC-LANC
[LTG=<number>],LTU=<number>,SLOT=<number>;
Examples
1.
Initiate loading of WAML configuration data.
Input:
EXEC-LANC:,2,25;
${DocTitle}
, ID:
${DocID}
©
02/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.