144.4 Error Messages and Advisories

144.4.1 Error Messages


F01:	AMO HAS BEEN STARTED TWICE
	AMO EXECUTABLE IF RUNNING TASK HAS PERFORMED
	OR
	AMO WAS ABORTED (USE ANOTHER SWU AMO TO ATTEMPT PROCESS RESET)
F02:	BOARD NOT ACESSIBLE
F03:	AT THIS SLOT THERE IS NO, A WRONG OR A NOT
	EXECUTABLE MARKED MODULE
F04:	INVALID COMMAND FOR MODULE
F05:	MAXIMUM DISPLAYABLE DUMP DATA (192K) EXCEEDED
F06:	DISPLAY STOPPED BY USER BREAK
F07:	MODULE DOES NOT RESPOND WITHIN THE DEFINED TIME
F08:	DATATRANSFER STOPED AFTER DISPLAY OF <DUMPLEN> BYTE
F09:	AMO EXCEPTION ERROR: COULD NOT SEND MESSAGE TO PP
F10:	AMO EXCEPTION ERROR: ERROR WHILE RECEIVING PP MESSAGE
F11:	RECEIVED DATA FROM BOARD INVALID
F12:	PP-TIMER EXPIRED
F13:	TIMER IN PP EXPIRED
F14:	LTU <ltu> HAS NOT BEEN ASSIGNED
F15:	No SLC24 board assigned to slot <ltu>-<slot>

Error message F07 is also displayed if a timeout occures at PP while waiting for response to the initial message (’START’ condition) to the board. The PP internal timer is in default settings half as big (10s) as the AMO-LWCMD message timer.

Error message F11 contains of three possible additional error reasons: Z1, Z2 and Z3. They shall give a deeper view of the reason why the AMO stops displaying the dump data if the reveived dump header is inconsistant for AMO-LWCMD to the system technician.

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.