145.5.2 Advisories


H01:	NO BLOCK IS ALLOCATED FOR THE SPECIFIED PARAMETERS
H02:	NO ANALOG BLOCK IS ASSIGNED
H03:	BLOCK <blockno> IS OF CIRCUIT TYPE <circtype>
H04:	SWITCH PEN <gg-u-sss-cc> OFF AND ON TO LOAD CIRCUIT PARAMETERS
H05:	PARAMETERS SMD AND MASTER MUST BOTH BE SET TO "Y" OR "N"
H06:	THE CHANGES WILL BECOME EFFECTIVE ONLY AFTER SWITCHING OFF AND SWITCHING ON THE FOLLOWING CDG CIRCUITS. (RESTART-DSSU)
H07:	THE CHANGES WILL BECOME EFFECTIVE ONLY AFTER SWITCHING OFF AND SWITCHING ON THE FOLLOWING CDG BOARDS. (DEACTIVATE/ACTIVATE-BSSU)
H08:	NO MATCHING SERVICE INFO FIELDS WERE FOUND FOR THE PATTERN GIVEN
H09:	IF THE PARAMETER INFOPAT OR FORMAT IS PRESENT IN THE COMMAND LINE, THEN THE VALUE FOR PARAMETER LWPARREF IS IGNORED
H10:	tHE PARAMETERS OF BLNO @@ HAVE BEEN RESET TO THEIR DEFAULT VALUE.
H11:	@@@@@@@=0 --> NO CHANNEL CONFIGURED. FURTHER PARAMETER VALUES ARE IGNORED.
H12:	THE FOLLOWING BLNO ARE OVERWRITTEN IN THE DATA BASE WHILE COPYING THE VARIANT @@@:
H13:	NO ENTRY FOUND.
H14:	BLNONEW @@@ OF TYPE @@@@@@ HAS BEEN OWERWRITTEN.
H15:	THE PARAMETER @@@@@@@@ AND @@@@@@@@ DO NOT HAVE THE SAME NUMBER OF VALUES. THE REST OF THE LONGER PARAMETER WILL BE IGNORED.
H16:	FOR THE SPECIFIED DXTG=255 THE ITR MUST BE ZERO. THE AMO IGNORES THE INPUT AND CONTINUES WITH ITR=0 FOR THIS DXTG.
H17:	CAUSED BY THE RECONFIGURATION THE PRIMARY DXTG HAS BEEN CHANGED FOR ITR = @@@. THE NEW VALUE FOR PARAMETER PRIMDXTG IS @@@.
H18:	PARAMETER PRIMDXTG IS IGNORED BECAUSE THE ITR BELONGING TO THIS DXTG AND THE ENTERED ITR ARE DIFFERENT.
H19:	SINCE UNIQUENESS OF THE <RRG/CBG> VALUES IS REQUIRED YOU HAVE TO ELIMINATE ANY MULTIPLICITIES BEFORE DOWNLOADING THE <LCOSVRRG/LCOSDRRG/TRGCBG> TABLE. THE FOLLOWING VALUES HAVE MULTIPLE OCCURRENCES: @@@ @@@ @@@ @@@ @@@ @@@ @@@ @@@
H20:	BDETON IS ONLY POSSIBLE, IF BISUB8ON IS SET TOO. BISUB8ON WAS NOT SET AND HAS NOW BEEN SET AUTOMATICALLY BY AMO.
H21:	IF THE PARAMETER TYPE IS SET TO TMD THEN THE VALUES FOR THE PARAMETERS INFOPAT, FORMAT AND DEV ARE IGNORED.
H22:	IF THE PARAMETER LNTYPE IS NOT COPPER THEN THE VALUE FOR THE PARAMETER COPTYPE IS IGNORED.

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.