151.2.1 ADD-PETRA

151.2.1.1 Creation of TRACE processes on standard modules (STD)

The create command is used to activate the trace procedure in a circuit. This causes one, several, or all processes (0...15) of the circuit to send the TRACE data to the periphery (PP).
Several TRACE procedures can be activated in sequence. These are executed in parallel. All results are marked for each LTG by the PP according to the sender and are collected in a common TRACE buffer. If the buffer overflows, this buffer is written again starting at the beginning (cyclic memory).

Each peripheral circuit requires its own job to activate the TRACER. The initiation of a circuit that has already been activated does not cause a fault; this permits activation of other processes of the same circuit.

Note:

In each case, only those processes which were specified in the last command are activated; previously activated processes, that were not specified in the last command, are deactivated.

Procedure Overview


Kommandocode	Parameter
ADD-PETRA	TYPE=STD,[LTG=<number>],LTU=<number>
	,SLOT=<number>,[CCT=<number>],PROC1=<number>
	,[PROC2=<number>];

Example

The processes 1, 3, 5 to 9 and 11 are to be traced from the LTG=1, LTU=2, SLOT=19, and circuit number=5.

Input:

ADD-PETRA:STD,1,2,19,5,1&3&5&&9&B;

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.