172.4 Error Messages and Advisories

172.4.1 Error Messages


F01:	FEATURE (DEVICE) IS NOT AVAILABLE - SWITCH ON WITH AMO FEACG
	Solution: switch on feature with AMO-FEACG
F02:	BLOCK SIZES ARE TOO LARGE, MAX @@@@@ STILL POSSIBLE!
F03:	MINIMUM NUMBER OF QUEUE ELEMENTS ARE NO LONGER PRESENT
	Solution: prompt values, decrease blocksize in the other Selectiongroups, until the minimum number of queue elements are available again.
F04:	SELECTION GROUP DOES NOT EXIST
F05:	not used
F06:	FORMAT OF THE BASE DEVICE MUST BE FORM01 TO FORM16
F07:	FORMAT OF THE RESERVE DEVICE MUST BE FORM01 TO FORM16
F08:	not used
F09:	SELECTION GROUP IS DELETED
F10:	SELECTION TABLE IS DELETED
F11:	TIME-LIMIT ENTRY NOT POSSIBLE
F12:	SELECTION GROUP ALREADY EXISTS
F13:	SELECTION TABLE ALREADY EXISTS
F14:	IF A SELECTION TABLE IS SPECIFIED, A SELECTION GROUP MUST BE SPECIFIED AS WELL
F15:	not used
F16:	ONLY FOLLOWING VALUES ARE FOR DESTCNT ALLOWED: A0...A22 OR L0...L22
F17:	IN CASE OF FAST OUTPUT THERE IS ONLY THE SELECTION GROUP 1 POSSIBLE
F18:	BASIC DEVICE NOT ALLOWED IN FAST OUTPUT MODE ONLY THE DEVICES TAPE, DPS AND FT ARE ALLOWED
F19:	RESERVE DEVICE NOT ALLOWED IN FAST OUTPUT MODE ONLY THE DEVICES TAPE, DPS AND FT ARE ALLOWED
F20:	PLEASE ENTER VALUES IN RISING ORDER

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.