10.2.2.11. Information on the 19“ AP 3700 IP Access Point 
The frame of an AP 3700 IP can be installed in 19“ cabinets. For
this, it must be set on sliding rails/mounting rails installed in the
cabinet and terminated at the cabinet uprights by means of the 19“
mounting bracket supplied.
AP 3700 IP required a height of 11 HE (10 HE + 1 HE play).
IMPORTANT:
AP 3700 IP is not forced ventilated and consequently,
does not feature a fan. For installation, please pay particular attention
to requirements in terms of air supply and minimum air volume specified
in the installation instructions.
The left half of the shelf can accommodate five peripheral boards
(slot 1 to 5). HG 3575-2 (NCUI2) is supported on the central slot (slot
6). The correct shelf half accommodates four peripheral boards (slot
7 to 10).
If the peripheral boards are not already equipped with a suitable
metal panel (for example, STMI2, slot 4 and 9), they are covered by a
metal panel that is inserted separately. (on slot 1 and 2 in the diagram).
Unused slots must be covered by a metal panel and guarantee the necessary
level of shielding.
Boards with front connectors can only be used if they are fitted with
a suitable metal panel (for example, STMI2, DIUN2 starting with status
-X-7, SLC24 starting with status -X200-9, PBXXX starting with status
-X-F3, ...)
SIVAPAC modules with adapters are not supported, because they do not
fit under the shielding cover. As an exception, a number of these boards
are fitted with a new plastic panel C39228-A402-C21. (TMEW2, SLMA,TMDID,TMEMUS).
The project planning guideline’s instructions on the installation
of peripheral boards should therefore be followed precisely.
At the rear, either the usual main distribution cables can be attached
or plug-in patch panels can be used to connect the devices directly using
Western plugs.
Up to three power supply modules can be connected side by side under
the board. Two modules are sufficient for supplying the maximum configuration.
A third module may also be connected as a redundant unit.
The power supply modules can be connected to the 115/230 V alternating
current or 48 V direct current. The three modules are fed over a shared
connected at the rear of the housing.
The right part of the AP 3700 IP can accommodate a survivability unit,
a cPCI cassette with a standalone emergency control unit.