Collapse AllExpand All

2.17.2.4.1. AMO GKTOP: Parameters in the Branch TYPE=RESMGMT1 Previous topic Parent topic Child topic Next topic

In principle, a distinction is made between the 2 sector types.
One sector type describes a gateway (GW), the other an IP segment of the customer’s network (LAN or WAN), which have respectively to be established as sector attributes.
Further description to the Attributes:
SECATTR: GW
This attribute must be set for gateway sector (HG 3570/HG 3575). Every GW sector must be connected to a LAN sector (unlimited bandwidth).
SECATTR: LAN / WAN
This attribute describes an IP segment in the customer’s network. It has to be set only in addition to the attributes OWN&EXCL.
The following rule must be considered:
The attribute LAN must be set, if the sector in the customer IP net is unlimited.
The attribute WAN must be set, if the sector in the customer IP net is limited.
WAN sectors are always located between LAN sectors!
HFA phones are not configured at a WAN sector. They are always assigned to a LAN sector.
SECATTR: OWN & EXCL
The sector is managed by RM as an own (OWN) node exclusively (EXCL). Without the attribute EXCL the RM does not seize bandwidth (for LAN) or does not count Channels (GW).
SECATTR: HHS / AP
These attributes are to be set (either/or) only in addition to the attribute GW and identify the shelf types that the GW situated are.
If the attribute AP is set, a sector path must be assigned to this sector (GW).
SECATTR: NODMC
This attribute blocks DMC (Direct Media Connection), if this sector is used for a call.
Sector attribute Sector type
O W N
E X C L
A P
H H S
N O D M C
GW
X
X
A
A
 
LAN/WAN
X
X
   
O
  • The unrestricted used attributes are marked with “X”.
  • Attributes, which are inside of a group defined with double lines, marked with “A” can only be used alternatively.
  • Attributes, marked with “O”, can be set optionally (depending on the use case).
The administration of the following parameters can be dispensed with depending on application case (sector types/attributes).
BANDWI:
Bandwidth in Kbit/s (Attention: BANDWI=0 means unlimited!)
GWLAN:
Sector number of the LAN in which the gateway is connected. The used B channels of a HG 3570/HG 3575 board can only be displayed with AMO GKTOP, if the GWLAN number is entered.
SECPANO1:
Sector path number 1 is used for the feature HFA and IPDA. Sector -path number 1 (SECPANO1) defines the way from the host to the remote sector, at which HFA phones or a HG 3575 gateway is connected to.
Under this sector path number all sectors passed through to reach this sector from a HHS are entered. The sector path number 1 begins with the sector nearest the HHS and ends with the most remote.
All sectors, which are between the HHS and the end point, have to be entered for this sector path.
The destination sector is not part of the sector path.
Because the RM is not released for IP trunking, the SECPANO2 and SECPANO3 are not used.
Example for the illustration “Example of Sector/cluster definition.....”: Sector path for cluster 1: 200&201 (not 202)