2.12.8. TYPE DMCDATA - Changing the Access Point Setting
to Support Direct Media Connections 
These parameters are used to set if or how many direct media connections
are permitted simultaneously on a specific HG 3575. The connections are
counted both in the OpenScape 4000 central system’s software and on
the board itself.
 |
Configuration Management > System Data > IPDA > IPDA
Access Point
Click Search and select the access point.
Enter under Direct Media Connection (DMC) enabled on the
General tab and Save.
|
 |
The access point must be switched off if you want to change the
value for DMCALLWD.
DEACT-USSU:LTU=19;If you only want to change the number of DMC connections
(DMCCONN) then the access point must not be
deactivated.
CHANGE-STMIB:MTYPE=NCUI2,LTU=99,TYPE=DMCDATA,DMCALLWD=YES,DMCCONN=30; |
This change does not become effective until the access point is restarted
or switched on again.
|
|
Configuration Management > System Data
> IPDA > IPDA System Data
Click Search and select
the access point. Click Execute on the Action pull-down
menu and select the mode of action Update AP, confirm with OK.
|
|
|
IF DMCALLWD has been changed the access point
must be switched on again:
ACT-USSU:LTU=19;If
the number of DMC connections (DMCCONN) has been changed an UPDATPA
must be performed:
EXEC-USSU:MODE=UPDATAP,LTU=99; |
IMPORTANT:
Connections are cleared down without further
warning when performing UPDATAP. Prior to the
EXEC-USSU:UPDATAP,
the configuration must be updated on the system hard disk.