2.12.17. Resetting the Parameters to Default Values 
If the parameters of one or all branches of the NCUI2/4 data are to
be reset to default values, e.g. after being changed temporarily for
diagnostic work, this can be performed in the INITNCU2 branch. The example
sets all ASC parameters to their default values.
 |
Initialization can only be initiated in expert
mode.
Expert Mode > OpenScape 4000 > Expert Access >
Open ...<IP> with AMO (see AMO command)
|
 |
CHANGE-STMIB:MTYPE=INITNCU2,LTU=17,TYPE=ASC; |
The changes under TYPE ASC, DSP, H323, JB, SNMP, MGNTDATA, WBMDATA
and DLSDATA become effective immediately without interrupting
operation.
Changes under TYPE GLOBAL, IFDATA, SERVIF, DMCDATA and SIGQOS become
effective after the access point has been restarted.
This behaviour is also valid for the command
CHANGE-STMIB:MTYPE=INITNCU2,LTU=17,
TYPE=ALL;. Therefore it is recommended
to restart the access point after resetting all parameters.|
|
Configuration Management > System Data
> IPDA > IPDA System Data
Click Search and select
the access point. Click Execute on the Action pull-down
menu and select the mode of action Update AP, confirm with OK.
|
|
|
EXEC-USSU:MODE=UPDATAP,LTU=17; |
IMPORTANT:
Connections are cleared down without further
warning. Prior to the
EXEC-USSU:UPDATAP, the configuration
must be updated on the system hard disk.