7.3.3. Activating the Large Enterprise Gatekeeper 
This step is only necessary if you do not want to run a Large Enterprise
Gatekeeper for least cost routing on the local OpenScape 4000 system.
The feature is active by default.
If you do not want a gatekeeper at the local OpenScape 4000 system,
then the feature must be deactivated in the system before HG 3500 is
installed. The GATEKPR parameter in the AMO ZANDE is used for
this.
IMPORTANT:
You cannot enable or disable the gatekeeper function
at an OpenScape 4000 system by simply activating or deactivating the
AMO ZANDE once HG 3500 generation is complete. Instead, you must remove
all STMI2/4 and STMIX/STMIY HG 3500 boards, activate/deactivate the ZANDE parameter,
and finally reinstall the boards. This sequence is necessitated by the
different configurations of feature-specific data.
Generation
AMO ZANDE
The AMO ZANDE is used on every OpenScape 4000 system to specify whether
or not this feature should be used.
 |
Configuration with the AMO ZANDE can only be
executed in expert mode.
Expert Mode > Expert Access >
Open ...<IP> with AMO (see AMO command)
|
 |
ADD-ZANDE:TYPE=ALLDATA,GATEKPR=YES; |
This command specifies that the LEGK address resolution function
(AMO GKREG) should be operated and administered at the local OpenScape
4000 system.
Table 18. AMO ZANDE parameters in the CHANGE branch under TYPE=ALLDATA
|
AMO
|
Parameter
|
Sprache/ Language
|
Beschreibung/ Description
|
|
ZANDE
|
GATEKPR
|
d
|
Gatekeeper Konfigurierung
Diese Parameter
muss auf NEIN gesetzt werden wenn eine PBX ohne Gatekeeper betrieben
werden soll. Standardmäßig wird JA, d.h. also ein Gatekeeper wird an
der lokalen PBX betrieben, eingerichtet.
|
|
GATEKPT
|
e
|
Gatekeeper configuration
This Parameter
must be set to NO when a PBX has to operate with-out a gatekeeper. Default
value is YES, that means a gatekeeper will be configured on the local
PBX.
|
Display
|
|
Displaying with the AMO ZANDE can only be executed
in expert mode.
Expert Mode > Expert Access > Open ...<IP>
with AMO
(see AMO command)
|
|
|
DISPLAY-ZANDE:TYPE=ALLDATA; |
Use this command to output all central parameters in the ALLDATA branch,
including the gatekeeper parameter.