18.3.5.1. New Access Point in an Active SPE System 
If you need to add a new access point while access point encryption
is already active, you need to do the following:
- Configure the access point in the system as usual with AMO UCSU, AMO APRT.
- Don't connect the access point yet because it will fail.
- Use SPE Administration in OpenScape 4000 Assistant and update the board list to see if your new access point has been added.
-
Expert Mode > Gateway Manager > SPE
- Configure a MEK manually for this access point. This will transmit the MEK to the RMX.
- Use the CLI to configure the same MEK on the NCUI.
- Now you can connect the access point to the LAN and activate the
connection to the system via
EXEC-USSU:MODE=CONFAP,LTU=<ltu_number>;.