7.2.2 CHANGE-ACSU

The function CHANGE makes it possible to modify the parameters defined during creation.

In general, only the new parameter value is entered. The AMO carries out the necessary cross-checks to other data and replaces the old value by the new if the checks are positive. Only when the ATNDNO, which must always be specified for identification, is changed the new ATNDNO have to be specified in parameter NEWNO.

An attendant calling number (ATNDNO) or the feature access group (DPLN) may be changed only if the attendant calling number is not referenced in an ACD routing table. It has to be previously removed by AMO ACDRT.

Procedure Overview


Command Code	Parameter
CHANGE-ACSU	ATNDNO=<number>,{NEWNO=<number>,DPLN=<number>
	,COS=<number>,LCOSV=<number>,SPDC1=<number>
	,SPDC2=<number>,LANG=<param>,EOVR=<param>
	,SATNDNO=<param>,NNO=<number>,
	,SRCGRP=<number,CLASSMRK=<param>
	,PUBNUM=<number>,TON=<param>,NPI=<param>};
	,[STNOOOS=<number>],[STNOAPE=<number>],
	,[AMOALTRT=<param>],[CLUSTID=<number>];

OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620

© 09/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.