17.3.1 ADD-APRT

•
TYPE=APNET
The values for APIPADDR, NETMASK and TAIPADDR are optional and will be generated by DB if not filled in. The following restrictions apply:
–
The APIPADDR is mandatory in the case of the AP connected via an IP network.
–
If the TAIPADDR is entered the APIPADDR has to be entered, too.
•
TYPE=SURV
CONF=ROUTER: assigns the address of a SL100 router and the address of a survivability router to a particular router number. It is neither necessary to enter a value for the routernr number nor to fill in values for the addresses, they will both be generated if not entered.
CONF=AP: configures APs for survivabilty by assigning them to a particular router that has been configured before with the branch CONF=ROUTER.
An AP can only be configured for survivability if the PFS counter for remote survivability is greater than the number of configured shelves for survivability.
•
TYPE=ALTROUT
Only in the case of ALRTYPE=ALR the further parameters can be used for the configuration of an alternate routing path.
The combination of alternate routing number, access code and artificial calling number has to be unique. If an artificial calling number range is entered all resulting artificial calling numbers will be checked against the already configured artificial calling numbers for the particular source group.
•
TYPE=ALTERR
ALRTYPE =OOS :
Configures the Out Of Service (by AMO) part of the Alternate Routing on Error table for the given Source Group. The combination of ALTRTNR and EXTNO is saved into the table together with the GWIPADR value.
ALRTYPE =APE :
Configures the Access Point Emergency part of the Alternate Routing on Error table for the given Source Group. The combination of ALTRTNR and EXTNO is saved. GWIPADR is not needed for the type APE.
The EXTNO is set to ZERO if the entered ALTRTNR is a Station Number.
Procedure overview
 
Command Code
Parameter
ADD-APRT
TYPE=APNET,LTU=<number>, [APIPADDR=<number>],
[NETMASK=<number>], [TAIPADDR=<number>];
 
| TYPE=SURV,
 
CONF=ROUTER,[ROUTERNR=<number>], [LSADDR=<number>];
 
| CONF=AP,LTU=<number>, ROUTERNO=<number>;
 
| SURVTYPE=MODEM;
 
| SURVTYPE=SURVLAN,SURVIP=<number>,
SURVNETM=<number>, SURVRT=<number>,
[VLANTAG=<param>], [VLANID=<number>]
 
| TYPE=ALTROUT,SRCGRP=<number>, [POS=<number>],
ALRTYPE=<param>, [ALTRTNR=<key-num>],
[ACCODE=<key-num>],
[ARTCNR=<key-num>], [ARTCNRNG=<number>];
 
| TYPE=ALTERR, SRCGRP=<number>,
| ALRTYPE=OOS, [ALTRTNR=<key-num>],
[GWIPADR=<number>], [EXTNO=<number>];
| ALRTYPE=APE, ALTRTNR=<key-num>,
[EXTNO=<number>];
OpenScape 4000 V11, Volume 1: AMO Descriptions, Service Documentation, Issue 6, ID: P31003H31A0S107067620
 © 05/2026 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.