28.4.3 EXEC-BDAT

This command initiates dynamic reloading of the entire configuration data during operation. The configuration data are also loaded to the module:
•
when adding with AMO BCSU
•
on insertion in the LTU shelf
•
when activating with AMO BSSU
The WAML2 does not use the configured data until successful loading.
The timing of the response from PIT is monitored using a timer.
If loading of the module data is unsuccessful the corresponding error message is output and the AMO is aborted. Loading may not be successful for the following reasons:
–
no module data has been added
–
the module is not present
–
an acknowledgment was not received from PIT within the 2-minute waiting time
–
the dynamic module identifier is not present
–
the module is not in the ’ready’ state
If the ADD and CHANGE functions are transmitted, the STMA module data are automatically loaded if this is possible. If loading is not yet possible at the time of adding/changing of the module data (e.g. module not inserted), they must be loaded later with this command.
Attention: the STMA module data can not be loaded with the EXEC command in operating mode NW20. To do this, the module has to be first deactivated and then activated again (with AMO BSSU).
Procedure overview
 
Command Code
Parameter
EXEC-BDAT
[LTG=<number>],LTU=<number>,SLOT=<number>;
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620
 © 09/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.