28.6.1 Error messages


F01:	ltu is out of range. allowed range from <xxx> to <yyy> <xxx> and <yyy> = 1 to 15
F02:	slot does not exist
F03:	global <stma/waml2> module data have <not/already> been configured
F04:	ltu has not been configured
F05:	atmprot=uni31 can not be used in operating mode 'interworking'
F06:	no <stma/waml2> module is configured in this slot
F07:	the circuit <x>-<xx>-<xxx>-<xxx> configured in the module uses vpi/vci values, which are not consistent to vciofs<y>=<zzz>. help: delete circuit then call amo bdat and configure the circuit again. <x>-<xx>-<xxx>-<xxx> = ltg-ltu-slot-circuit; <y> = 0 to 7; <zzz> = 0 to 255
F08:	the stma module is not with the required operating mode configured. (see amo bcsu, parameter fctid)
F09:	slot without ltu, an ltu number must be entered
F10:	data have not been loaded: module is not in state 'ready'
F11:	module data could not be loaded
F12:	the load of module data was not acknowledged
F13:	the dynamic module-id is not available
F22:	the vpi<x> based on vciofs<x> is already assigned to a psw subscriber. vci offset can not be changed. <x> = 0 to 7
F24:	there are formal errors in the ip-address <nnn.nnn.nnn.nnn> <nnn> = 0 to 255
F25:	the ip-address 255.255.255.255 in parameter <ipaddr/ipadrnew/nextroute> is not allowed
F26:	the entered network interface has <not/already> been configured
F27:	the entered ip-address has <not/already> been configured
F28:	table '<iproute/firemac>' is full, no entry possible
F29:	there are formal errors in the mac-address <nn.nn.nn.nn.nn.nn> <nn> = 00 to FF (hexadecimal)
F30:	the ip-address of parameter <ipaddr/ipadrnew> has <not/already> been configured
F31:	no data have been configured
F32:	to change the global parameters, the stma module has to be deactivated (amo bssu).
F33:	to change parameter <fuellgrd/ipaddr>, the <stma/waml2> module has to be deactivated (amo bssu).
F34:	the entered network mask can not be used if destination=net
F37:	the stma module data for 'nw20' have <not/already> been configured
F39:	all vpci values have to be different
F40:	the entered atm address is already used by the stma module 1-<ltu>-<slot> in operating mode 'nw20'. attention: the atm address must be unique networkwide!
F41:	atmprot=unitest can be set only in operating mode 'nw20'.
F42:	in operating mode 'nw20' the module data can not be loaded with exec-bdat. to load these module data, the stma module has to be first deactivated and then activated again (amo bssu).

OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620

© 09/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.