35.2.3 RESTART-BSSU

This function resets boards; that means the commands DEACTIVATE and ACTIVATE are combined in one order. For ranges all devices will be deactivated first and activated afterwards. All deactivations will be done with OFFTYPE= DI, all activations will be done with ONTYPE=AUL. The last reference clock generator can not be reset by means of this function, the message H28 will be displayed.
WTIME parameter is used to have a pause time between activation and deactivation process.
HFASW parameter is only valid for STMI2-HFA board, for the rest of the boards this parameter is ignored.
STMI2-HFA boards
HFASW parameter is ignored for the boards different from STMI2-HFA . Possible values and the functionalities behind are as follows :
HFASW = IPSTNBCK : After deactivation of the STMI2-HFA , AMO switchs (reconfigures) back the IP terminals which had been originally configured at the specified board and activates the specified board. The DC state of the specified (standby) board must be MAN_AMO/DEF, where the destination board ( from which the IP terminals are swithced from ) must be DEF or READY.
HFASW = STBYRDY : After deactivation of the board, AMO activates the specified board and changes its Standby Mode from ...STDBY_DEF to ...STDBY_READY.
HFASW = NONE : AMO just deactivates and activates the STMI2-HFA board .
HFASW parameter is only valid for STMI2-HFA board, for the rest of the boards this parameter is ignored.
HFASW = SWITCH: Manually switches the IP terminals from the specified board ( LTG-LTU-SLOT) to the destination board (LTG2-LTU2-SLOT2). If the destination board is not entered by the user then AMO searchs for an appropriate standby board ( Standby Ready Mode) in the reconfiguration pool which the specified board is a member of.
Standby Mode of the destination board must be STBYRDY,
 
 
Procedure Overview
 
Command Code
Parameter
RESTART-BSSU
ADDRTYPE=ALL,WTIME=<number>;
 
| ADDRTYPE=PARTNO,PARTNO=<string>,[FCTID=<number>], WTIME=<number>;
 
| ADDRTYPE=PEN,[LTG=<number>],LTU=<number>,SLOT=<number>, |[WTIME=<number>],
 
| [HFASW=NONE];
 
| [HFASW=IPSTNBCK];
 
| [HFASW=STBYRDY];
 
| [HFASW=SWITCH],[LTG2=<number>], | [LTU2=<number>],[SLOT2=<number>];
Example
The module at LTG 1, LTU 2, SLOT 25 is to be activated with conditional loading.
Input:
RESTART-BSSU:1,2,25;
Output:
H23: MODULE 1.2.25 DEACTIVATED
H02: MODULE 1.2.25 ACTIVATED
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620
 © 09/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.