65.2.4 EXEC-DBC

65.2.4 EXEC-DBC

Change the database configuration data taking into account the data from the hardware configuration table.

NOTE: This AMO action was introduced to facilitate system generation. After the parameters ARCH and ARCHTYPE have been entered, a table is checked on the hard disk. All the necessary values are then taken from this table. The table can be read with the following command:
STA-LIST:":PDS:APSU/HWARCH0",,,M,N;

This table is generated by STARTUP and should not be modified.

Procedure Overview


Command Code	Parameter
EXEC-DBC	ARCH=<param>,ARCHTYPE=<param>

Generate the following system: SYSTEM 600, EXTENDED-COMPACT-EXTENDED, DUPLEX

EXEC-DBC:350E,35;

EXEC-DBC:350E,35;
H500: AMO DBC STARTED
H01: IN ORDER TO LOAD THE CHANGES IN THE CONFIGURATION TABLE, INITIATE
RELOAD AND GENERATE THE SWU-DATABASE.
H04: EXEC-APC TASK MUST BE CARRIED OUT.
AMO-DBC -109 DATABASE CONFIGURATION
EXEC COMPLETED;

If the CONFIGURATION DATA cannot be loaded, the AMO is terminated and error message F04 issued.

If the hardware architecture table cannot be loaded, the AMO is terminated and error message F12 issued.

If the hardware architecture table contains incomplete and/or invalid values, the AMO is terminated with error message F14.

Each time the command EXEC-DBC is applied to the configuration table, the version counter is incremented by the AMO. As a result of this, the customer database is reset, i.e. the customer data is deleted.

In such a case, the customer database must be REGENERATED !

OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620

© 09/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.