68.3.2
DEACTIVATE-DDRSM
With the function DEACTIVATE-DDRSM for area(s) (an) existing double recording(s) between the master and slave areas will be deactivated, pair allocation(s) will be deleted, and the defined area(s) will be deactivated.
With the function DEACTIVATE-DDRSM for a device (always all areas of the device are affected!) all existing double recordings of the device will be deactivated, the pair allocations will be deleted and the specified device will be deactivated.
If the function DEACTIVATE-DDRSM is executed during a synchronization process, the state of the corresponding areas will be set to
INCONSISTENT
.
’PHY’-areas cannot be deactivated.
Procedure Overview
Command Code
Parameter
DEACTIVATE-DDRSM
[UNIT=<param>],ID=<number>,[AREA=<param>]
,[REPLY=<param>];
Examples
1.
Deactivate device on controller 2 and delete pair allocations of all areas on this device.
Input:
DEACT-DDRSM:,2;
2.
Deactivate area E on controller 2 and delete pair allocation of this area.
Input:
DEACT-DDRSM:A1,2,E;
3.
Deactivate areas F and G on controller 2 and delete pair allocations of these areas.
Input:
DEACT-DDRSM:,2,F&G;
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.