78.10.2 Advisories

 
H01:
ONLY <xxxx>H BYTES CAN BE ACCESSED
 
This messages explains the reason for a failed attempt at read or write access.
H02:
NO DATA FOUND
 
This message explains the reason for a failed attempt at data output.
H03:
REQUESTED FUNCTION NOT AVAILABLE
 
This messages means that the input function or command is not available on the processor accessed, or is not applicable.
H04:
S0-BUS, CIR- AND LN- ADDRESS CAN’T RETURN A SINGLE DEVICE-ADDR;
USE STNO OR LODEN
 
It is not possible to address a single device on the S0 bus by means of a circuit or line address. Please use station number or loden.
H05:
THERE IS NO DEVICE TABLE ELEMENT FOR SELECTED SERVICE: DI=<x> (<xxx>)
 
S0 bus only with functional terminals; no DH device memory currently available for stipulated service (DI). The output has been performed only with the global DH device memory of the S0 bus.
H06:
<xxxxx>T BYTES COPIED INTO FILE "<xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>"
 
Notice relating the number of bytes written into the stipulated file.
H07:
S0-BUS LINE; PARAMETER ’DI’ INPUT USED AS SERVICE INDICATOR ’SI’
MEMORY DISPLAY FOR SVC = "<xxx>"
 
This advisory message means, that the given circuit- or line-address belongs to a S0-bus and the value of parameters ’DI’ is handled as a SERVICE INDICATOR ’SI’. The device memories of ALL terminals of the given service will be detected and put out on the user terminal.
 
 
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620
 © 09/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.