114.3.7
OUTPUT-HISTA
This function serves to output files (Hicom Teleservice protocol files) written cyclically
by the FILE TASK.
Cyclic organization means that when writing a file of limited length, the system
returns to start of file as soon as the file is complete.
The old contents are then overwritten from the beginning.
Procedure Overview
Command Code
Parameter
OUTPUT-HISTA
FILENAME=<string>,
[ADDR=<number>],[LEN=<number>]
,[BOTTOM=<param>],[ANS=<param>];
Parameter description
FILENAME
The name of the C file must begin with “C-“, the AMO adds the prefix :AMD:.
If no file is specified, “:AMD:C-FBTHIST“ will be used as the file name.
ADR
If the parameter ADR is specified, output starts at this fault message.
LEN
If the parameter LEN is specified, the number of fault messages to be output corresponds to the number specified by LEN, output either starts at the most recent fault report in the file, or if ADR has been specified, at the fault message which lies ADR positions before the most recent message.
BOTTOM
If the parameter BOTTOM is specified (BOTTOM=YES), the number of oldest fault messages which was specified by LEN will be output, output either starts at the oldest fault message in the file, or if ADR has been specified, at the fault message which is offset by ADR positions from the oldest message.
ANS
Determines whether the user is to be prompted to “Continue (Y/N)“ the output of long blocks.
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.