123.3.2
CHANGE-KNFOR
This command allows you to change the values of TONIN/TONOUT, SCRE, SENDCALL, SENDCONN and OVRDCAT for a destination number that has already been defined. You must specify at least one of the parameters. The value of the parameter for which no entry is made is retained in the database unchanged. TONIN/TONOUT values can also be reset.
Procedure overview
Command Code
Parameter
CHANGE-KNFOR
DNNO=<number>
|,NPI=ISDN,{TONIN=<param>,TONOUT=<param>,SCRE=<param>
,SENDCALL=<param>,SENDCONN=<param>,OVRDCAT=<param>
,ERROPT=<param>};
|,NPI=PRIVATE,{TONIN=<param>,TONOUT=<param>,SCRE=<param>
,SENDCALL=<param>,SENDCONN=<param>,OVRDCAT=<param>
,ERROPT=<param>};
Example
1.
Change the value of the TONIN parameter for a destination node number that has already been added and reset the TONOUT value.
Input:
CHANGE-KNFOR:DNNO=3-1-20,NPI=ISDN,TONIN=UNKNOWN,TONOUT=RESET;
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.