125.6 Error messages and advisories

125.6.1 Error messages

 
F01:
CONNECTIONS FROM <aaa> TO <bbb> IN LEVEL <c> CANNOT BE DENIED SINCE THE
MEMORY AREA WHICH WAS ASSIGNED BY MEANS OF THE AMO DIMSU
PARAMETER RSTCON HAS ALREADY BEEN USED UP.
F02:
STATION NUMBER MODIFICATIONS FROM NODE <ddddd> TO NODE <eeeee> IN LEVEL <c>
CANNOT BE ENTERED SINCE THE MEMORY AREA WHICH WAS ASSIGNED BY MEANS OF
THE AMO DIMSU (PARAMETER DSPMOD AND DPDSPMOD) HAS ALREADY BEEN USED UP.
F03:
MODCON = NOMOD MUST NOT BE CONCATENATED WITH OTHER VALUES.
F04:
FOR CHANGING A MODIFICATION VALUE (MODCON, NUMEXT, NUMRED), NPI IS
MANDATORY.
F05:
LOGICAL NODES (PARAMETER ONNOL, DNNOL) ARE NOT ALLOWED FOR DENYING
CONNECTIONS.
F06:
<fffff> = <ggg> IS OUT OF RANGE FOR LEVEL = <c>. POSSIBLE RANGE: 1 - <hhh>
F08:
<fffff> IS ONLY VALID FOR A SPECIFIC LEVEL.
F09:
TOO MANY ENTRIES FOR DENIED CONNECTIONS OR MODIFICATIONS: THE MAXIMUM
RUNTIME WAS EXCEEDED. THE ENTRIES UNTIL NODE <ddddd> OF LEVEL <c> HAVE BEEN
EXECUTED.
PLEASE ENTER COMMAND AGAIN FOR THE REMAINING NODES.
F10:
THE LOGICAL NODE ’OWN’ IS ONLY ALLOWED FOR NPI=UNKNOWN AND LEVEL=0
F11:
THE SPECIAL VALUE ##### IN PARAMETER NUMEXT/NUMRED IS ONLY ALLOWED FOR
THE LOGICAL NODE ’OWN’. EITHER ONNOL OR DNNOL MUST BE ’OWN’.
F12:
OWN NODE ID’S COULD NOT BE PICKED UP FROM KNDEF-TABLE BECAUSE NODE ID <ggg>
IS NOT UNIQUE IN LEVEL 0 IN KNDEF-TABLE.
F13:
OWN NODE ID’S COULD NOT BE PICKED UP FROM KNDEF-TABLE BECAUSE
THE KNDEF-TABLE FOR OWN NODES IS EMPTY.
F14:
OWN NODE CODES COULD NOT BE EXTRACTED FROM KNDEF-TABLE
(NO ENTRY IN KNDEF FOR NODECD OR NODECDSK).
F15:
MODCON IS ONLY VALID IN COMBINATION WITH NUMBER EXTENSION OR REDUCTION.
MODCON WAS IGNORED BECAUSE NO NUMBER EXTENSION OR REDUCTION WAS FOUND
EITHER IN COMMAND OR IN MODIFICATION MATRIX.
F16:
ONNOL AND DNNOL MUST NOT BE BOTH ’OWN’ IF NODE CODES ARE TO BE
EXTRACTED FROM KNDEF-TABLE (NUMEXT/NUMRED=#####).
Output texts:
 
<aaa>:
Originating node / region number
<bbb>:
Destination node / region number
<c>:
Level
<ddddd>:
Originating node / region number or OWN, ROW or CDR
<eeeee>:
Destination node / region number or OWN, ROW or CDR
<fffff>:
Parameter ONNO or DNNO
<ggg>:
Node / region number
<hhh>:
Highest permissible node / region number
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5, ID: P31003H31A0S107057620
 © 09/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.