151.2.5
STOP-PETRA
Stopping the TRACE memory allocation:
This command is used to force the release of the buffer segment in the periphery.
If the PP subsequently receives a TRACE data record from a module, the PP sends the command "deactivate tracer" to the module, thus stopping further tracing.
This command should be input at the end of all TRACE procedures in order to make the memory area of the trace data segment in the PP available again and prevent the modules continuously sending trace data and overloading the dynamics.
Procedure Overview
Command Code
Parameter
STOP-PETRA
[LTG=<number>];
Example
The TRACE memory allocation and the trace function in LTG=1 is to be stopped.
Input:
STOP-PETRA:1;
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.