174.2.1
ACTIVATE-SELS
Switch on the selection group, i.e., the state "ON" is entered into the status code of the selection group.
At this time, the AMO checks to ensure that the corresponding selection group is created with at least one selection table.
In the operation mode "fast output" it will be checked if the value for the selection group is bigger than 1. In this case an error message occurs.
Procedure Overview
Command Code
Parameters
ACTIVATE-SELS
SELGRNO=<number>;
Example
1.
Switch on selection group 1
Input:
ACTIVATE-SELS:1;
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.