7.1.7.5. Changes in the AMO GEFE 
This is where you specify whether the attendant or secretary are assigned
their own charges or if the charges are passed on to the other party.
This can be set independently for incoming and outgoing connections.
COSTDUTY OF ATTENDANT / SECRETARY INCOMING : |
NO |
OUTCOMING : |
NO |
If two outgoing calls are connected to each other, this parameter
allows or blocks a possible change to the connection direction of one
of these two calls (in this case, from "outgoing" to "incoming").
CHANGE OF CALL DIRECTION IN TICKET SEQUENZ : |
YES |
The parameter shows renewed ringing for a call that was already put
through. In this case, SupplService is changed to Ring_after_connect.
NEW RINGING, THROUGH CONN. CALL IN RINGDUR : |
NO |
The parameter allows the queuing duration to be output without enabling
the CDRE feature.
OUTPUT OF QUEUE_DUR WITHOUT ACTIVATION OF CDRE : |
YES |
A user identified as "confidential" is suppressed in the CALLIPTY
output field (AMO FTBL). This user is usually also the paying party (as
Calling). This parameter can be used to allow or block the output of
this confidential user in the PayingParty field.
SHOW RESTRICTED SUBSCRIBER IN PAYINGPARTY : |
NO |
You can also specify whether the destination number should be shortened
by two digits.
DESTINATION NUMBER SHORTENED BY 2 DIGITS : |
NO |
Should a new ticket and therefore a new call detail record be generated
if the other party involved in the call with the paying party (PP) changes
because of forwarding or similar.
TICKET BY SAME PP : |
YES |
Call charge units received by the carrier are entered in the field
Field CHUNIT. If YES is set, the call charge information from the CO
is entered in NETPULS while internally calculated call charge data is
entered in CHUNIT.
OFFICIAL UNITS ARE SAVED IN CDB : |
YES |
With incoming call detail recording, the called party is entered as
the paying party. This is not always correct. This parameter changes
the calling party into the called party.
INCOMING CALLING IN THE FIELD OF CALLING : |
NO |
Information for AOCs
AOC-S COST CALCULATION CONFIGURATION
THROUGH CONNECTED
BASIC COMM : YES
CALL ATTEMPT : NO
CALL SETUP : YES
UUI : NO
OP. OF. SS. : NO (Basic charge for special
services)
NON THROUGH CONNECTED
BASIC COMM : YES
CALL ATTEMPT : YES
CALL SETUP : NO
UUI : NO
OP. OF. SS. : NO (Basic charge for special
services)
- Use KNMAT to make changes
NODE ID HANDLING INTERNAL : NO INCOMING : NO OUTGOING : NO - In an E164 numbering plan, the prefix is added to the station number
PREFIX HANDLING OF STATION INTERNAL : NO INCOMING : NO OUTGOING : NO CARRIER TYPE OF CALL DETAIL REC. AT METHODS FOR CALL DETAIL REC. CONNECTION END NORM SPEC PUBL OPER 0 MIX NO 0 0 0 0 1 MIX NO 0 0 0 0 2 MIX NO 0 0 0 0 3 MIX NO 0 0 0 0 4 MIX NO 0 0 0 0 5 MIX NO 0 0 0 0 6 MIX NO 0 0 0 0 7 MIX NO 0 0 0 0 8 MIX NO 0 0 0 0 9 MIX NO 0 0 0 0