8.2.3.5.4. Configure call pickup throughout the network on PBXXX 
- If a circuit leads to the PBXXX, you must use "Extended Facilities" instead of segmentation
for
the EConfiguration ManagementA-V2 protocol. The circuit needs the COP parameter ASEG
and you
must configure the following in the AMO PRODE:
You can only administer a protocol change in expert mode. Expert mode --> ComWin --> Open ...< IP> using AMO (see AMO command).
Make the changes in the protocol with the AMO PRODE:CHANGE-PRODE:KIND=PD,PDNAME=PD14,SEC=WELMAND,SETNO=14,B10=40,B30=40;CHANGE-PRODE:KIND=PD,PDNAME=PD14,SEC=WELMAND,SETNO=46,B10=42,B30=42;CHANGE-PRODE:KIND=PD,PDNAME=PD14,SEC=WELNAME,CS=00,NO=13,B00=06;CHANGE-PRODE:KIND=PD,PDNAME=PD14,SEC=RESTP,PDBLK=WELHEX,NO=12,B00=0D;CHANGE-PRODE:KIND=PD,PDNAME=PD14,SEC=ORG,ACTIVE=Y;