- Exchange a voice terminal:
CHA-SXSU:STNO=number,TYPE=DEV,OPT=param,DVCFIG=param,...;
All terminals that are not supported by the AMO SXSU can
be modified by deleting the old device and configuring a new port with
the appropriate data. In these cases, if the parameters and features
of the old device configuration are to be taken over, you must display
and/or save the appropriate data before you delete the configuration
data, so that you can re-assign them to the new device configuration
as required.
- Display station data:
DIS-SCSU:STNO=number; or
DIS-SBCSU:STNO=number;
- Save device configuration data and features with REGENERATE commands.
REG-SCSU:STNO=number;
or
REG-SBCSU:STNO=number;
or
REG-SSCSU:STNO=number;
REG-AUN:TYPE=STN,STNO=number;
REG-SA:CD=number;
REG-NAVAR;
REG-SDAT:STNO=number;
REG-COMGR:TYPE=STN,STNO=number;
REG-PERSI:TYPE=STN,STNO=number;
REG-ZIEL:TYPE=FWD,SRCNO=number;
REG-ZIEL:TYPE=NAME,SRCNO=number;
REG-ZIEL:TYPE=SPDI,SRCNO=number;
REG-ZIEL:TYPE=SNR,SRCNO=number;
REG-TGER:STNO=number;
Additionally, for messenger, DSS and executive/secretary
destinations:
REG-ZIEL:TYPE=MSGR,SRCNO=number;
REG-ZIEL:TYPE=DSS,SRCNO=number;
REG-CHESE:TYPE=STN,STNO=number;
- Delete the device configuration data:
DEL-SCSU:STNO=number,CMIND=ALL,OFFTYPE=DI;
or
DEL-SBCSU:STNO=number,SVC=ALL,OFFTYPE=DI;
or
DEL-SSCSU:STNO=number,OFFTYPE=DI;
- Re-assign station (see Section 142.1,
"Adding a Station (Example)")
In the ADD command which results from the REG-SCSU/SBCSU/SSCSU command,
you must change the parameter DVCFIG to the new terminal type and, where
applicable, replace the AMO names and adapt the parameter tree (for example,
if you want to replace an ANATE for an optiset E). Re-assign station
data and features with the remaining ADD commands.
