10.60.3.1. AMO batch for DSS1 terminals 
Configuration of UUS1 Implicit:
The calling party must have the classmark for UUS1 Implicit (UUS1IM).
Only the calling party can activate this service. The called party does
not require the classmark for UUS1 Implicit:
Provided, the COS number 6 is set for a DSS1 station:
CHA-COSSU:TYPE=COS,COS=6,AVCE=UUS1IM;
Configuration of UUS3 for DSS1:
The calling party must have the classmark for UUS3.
CHA-COSSU:TYPE=COS,COS=6,AVCE=UUS3;
Changes in the option table
IMPORTANT:
Changes in the option table affect all terminals
assigned to this particular index number (IDX).
The data rate can also be administrated in option table 10:
- the burst parameter: maximum number of data blocks which can be transmitted within
10
seconds
CHA-ZAND:TYPE=OPTTBL,IDX=10, BYTE=42, VALUEOPT=10;
- the incrementation parameter: every 10 seconds an internal counter which controls
the
data rate is increased by the value assigned to this parameter, until the counter
is equal
to the burst
parameter.
CHA-ZAND:TYPE=OPTTBL,IDX=10, BYTE=43, VALUEOPT=08;
Bit 2 of byte 2 in option table 10 may not be set in the option table
for DSS1 terminals. Bit 2 specifies whether the service will be activated
protocol compliant or proprietary for CMI and network-wide CHESE.
CHA-ZAND:TYPE=OPTTBL,IDX=10, BYTE=2, VALUEOPT=E1;
If a call is redirect, the User-to-User service request:
- can always be redirected (only DSS1
terminals)
CHA-ZAND:TYPE=ALLDATA2, UUS=DIV;
- can not be redirected
CHA-ZAND:TYPE=ALLDATA2, UUS=NODIV;
- can only be redirected if the redirecting party has the required UUS
classmark.
CHA-ZAND:TYPE=ALLDATA2, UUS=DIVSUB;