138 LODR - Administration of LCR Outdial Rules

OUTCODE - Outpulse the authorization code (AMO LAUTH)

Outpulse the authorization code for network access stored with AMO LAUTH;
the network operator’s number must be specified in parameter INDEX.
OUTCODE is only available, if feature package ‘LCR COMFORT’ or
‘NETWORKING COMFORT’ is included.

•

OUTCOEX - Outpulse the class of external

The class-of-external’s number must be specified in parameter COEX.

•

OUTCSN - Outpulse the call serial number

The network operator’s number must be specified in parameter INDEX.
OUTCODE is only available, if feature package ‘LCR COMFORT’ or
‘NETWORKING COMFORT’ is included

•

OUTPULSE - Outpulse specific digits

The digits must be specified in parameter DGTS.

•

CPNLIN - order to send an up to a 22-digit CPN or LIN via DTMF tones on an analog E&M tie trunk. The digits must be specified in parameter DGTS.

•

NWOP - The network operator command, when assigned to an outdial rule, requires further configuration of the parameter OPTYPE to indicate the type of operator to be requested. The following values may be assigned to this parameter:
– PRINOP = request principal operator (e.g., when the user dials 0, 0+ or 01+)
– ALTOP = request alternate operator (e.g., when the user dials 00 or 00+)

•

PAUSE - Start a pause timer for a specified duration

The timer value must be specified in parameter TIME.

•

SENDCOMP - Sending complete

Send info element sending complete

•

SENDNOW - Send second digit block now

It interrupts the execution of an out dial rule: The Setup message to DIUS7 contains the digits of the current dialling plan which have been processed prior to the interruption. On reception of the Setup_Ack message from DIUS7 LCR checks if further out dial rule commands have to be processed. If so the out dial rule is continued and the remaining digits are sent to DIUS7 in an info message. The new command SENDNOW is allowed only once in an out dial rule, because an out dial rule can be continued on reception of a Setup_Ack only.

•

TON - Type of number

(according to NPI - Network plan identifier, see Table 1) As a single value TON cannot be added into the ODR.

•

WAITANS - Wait for dialing tone

The timer value must be specified in parameter TIME.

•

END - The end of the ODR command sequence

${DocTitle}, ID: ${DocID}

© 02/2025 Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.