185.5.2 Advisories

 
H01:
ANNOUNCEMENT TYPE <xx> WAS ASSIGNED TO ANNOUNCEMENT
 
If the user attempts to set up an announcement without explicitly specifying the announcement type, the AMO determines the next free entry in the announcement table. This index corresponds to the annnouncement type of the specified announcement properties and is reported to the user.
H02:
ANNOUNCEMENT TYPE <xx> ALREADY USED IN MATRIX <xxxxx>
 
This advisory indicates in which announcement matrix the specified announcement type has been entered.
H03:
NO DATA FOUND
 
This advisory explains why the expected data output fails. No corresponding data exists.
H04:
DELETE ENTRIES FOR ANNOUNCEMENT TYPE IN ANNOUNCEMENT MATRIX: Y/N
 
This advisory prompts the user to confirm a hidden delete job.
H05:
THE ANNOUNCEMENT TYPE <xx> WAS ASSIGNED <xxxx> ANNOUNCEMENT DEVICE
 
This advisory notifies the AMO user that no/one announcement device has been assigned to the announcement type. The assignment can be processed by means of the AMO TSCSU.
H06:
ANNOUNCEMENT TYPE <xx> HAS BEEN DEACTIVATED
 
This advisory indicates that the request to delete an announcement type was canceled by the user but that the announcement was deactivated automatically. All data and cross-references of the announcement type are retained.
H07:
TABLE TYPE: <XXXXX> - NO DATA FOUND FOR ANNOUNCEMENT TYPE <XX>
 
For this announcement type no entries in the matrix have been found
H08:
THE OPERATION MODE OF ANNOUNCEMENT TYPE HAS BEEN CHANGED.
 
The operation mode - start/stop or continuous - of the announcement type has been changed.
H09:
NO VALID ANNOUNCEMENT REASON HAS BEEN ENTERED FOR MATRIX.
 
For the specified announcement matrix no valid announcement reason has been entered.
H10:
ANNOUNCEMENT TYPE(S)<xx> TO <xx> NOT ESTABLISHED
 
The specified announcement type(s) of the entered interval (e.g. old announcement type) do(es) not exist in the announcement type table. Therefore it isn’t possible to process it as wanted. The command is executed as ordered only for all existing announcement type(s) of the interval.
H11:
FOR CHANGE OF OPERATION MODUS THE PARAMETER <xxxxxxxx> HAS TO BE ENTERED.
 
Although the parameters RELLIMIT resp. DELAYTM are originally optional a value has to be specified when the operation mode is changed.
H12:
THE COMPIDX WILL BE DETERMINED FROM THE LAST NUMBER OF ACCESS CODE
 
${DocTitle}, ID: ${DocID}
 © 02/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
 All other trademarks herein are the property of their respective owners.