198.1
Interrelationships
The AMO TSCSU is dependent on data administrated by other AMOs.
•
AMO BCSU
:
Board configuration, switching unit
The AMO BCSU configures modules for trunks
•
AMO BUEND
:
Trunk group access code
The AMO BUEND prepares empty trunk groups and administers their memory sizes.
•
AMO COP
:
Class of parameter for device handler
The AMO COP is used to enter line parameters which can be assigned to trunks using the parameter COPNO.
•
AMO COT
:
Class of trunk for call processing
The AMO COT is used to enter line parameters which can be assigned to trunks using the parameter COTNO.
•
AMO CTIME
:
Customer-specific timers, switching unit
Timers assigned by the AMO CTIME are assigned with the parameters WAITT, DELANS and WAIT
•
AMO DTIM1
:
Device handler timers
Timers set by the AMO DTIM1 are assigned using the parameters SUPV, STADIAL, EOD and TBT.
•
AMO DTIM2
:
Device handler timers
:
Timers set by the AMO DTIM2 are assigned using the parameter STADIAL.
•
AMO RICHT
Routing
The AMO RICHT is used to assign an route access code to trunk groups for outgoing/incoming traffic
•
AMO SYNCA
Synchronized, customer specific announcement
The AMO SYNCA is used to assign the announcement type which must be allocated to a RAS device by parameter ANNTYPE
•
AMO VADSU
:
Administration of NMC alarms in the SWU
The AMO VADSU is used to assign alarms, which can be assigned to trunks (see parameter ALARMNO)
Interrelationships to parameters from other AMOs
Interrelationships of COTs to the COPs:
ANS (answer form the line) may only be set if the parameter ANS (line with answer) is set in the COP.
${DocTitle}
, ID:
${DocID}
©
02/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
All other trademarks herein are the property of their respective owners.