Collapse AllExpand All

10.4. Local Access Point Administration at CLI via Terminal Previous topic Parent topic Child topic Next topic

If an LCT/service PC running “Expert Access“ is not available for the local configuration of an access point, the administration may also be performed directly via a terminal or terminal emulation, if necessary.
The RS 232 / V.24 interface at the 3575 is labeled with “Service“ and is set to 38400 Baud, 8 Bit, no Parity.
The Command Line Interface issues the following message after you press
=:
Please log in.
Username:

Login data

  1. new board (before installation)
  2. Login: HP4K-DEVEL
    Password: 4K-admin
  3. after installation (OpenScape 4000 steuert NCUI4)
  4. Login: TRM
    Password: HICOM
    If the module was already in operation and if the WBM login and password were changed, then the values set apply.
    The following is displayed after successful login:
    Welcome to the HG 3575 V4.0 <currently loaded LW-version> Command Line Interpreter.
    vxTarget>
    After the prompt, the necessary parameters can now be entered.
    A list of available commands can be now requested via the local help function which is available via the help command.
    The CLI does not distinguish between “direct link“ and “networked“ access points. The designation of the parameters reflects the programming name of the loadware. As already mentioned, direct operation of the CLI without the “Expert Access“ application is only an emergency solution.
    The following tables are intended to assist in finding the correct content for the parameters. The tables list the requisite CLI parameters and arrange them in relationship to the AMO parameters from which the values have to be derived: