Collapse AllExpand All

2.21.2.2. IPDA (HG 3575/HG 3500) + DMC (HG 3575) master connections Previous topic Parent topic Child topic Next topic

  • IPDA master connections
  • The UDPPORT parameter in the AMO SIPCO is used for the payload stream in the IPDA master connection, i.e. for connections between the IPDA-HG 3500 and the HG 3575 and vice versa and for connections from HG 3575 to HG 3575.
    For IPDA master connections, only the start value is defined in the AMO SIPCO, TYPE=DIFFSERV, UDPPORT=<4352 ... 65083>. The upper value (=maximum number of ports actually used) is calculated on the basis of the number of B channels of the board used.
    The port with the lowest value can be set to even values in the range [4352 ... 65280].
  • DMC slave connections
  • The UDPPORT parameter applies to the AMO SIPCO for DMC slave connections where NCUI2+/NCUI4 is the DMC endpoint. The following ports are used automatically.
    The port range from the AMO CGWB (UDPPRTLO-UDPPRTHI) applies to slave connections where STMI2/STMI4 and STMIX/STMIY is the DMC endpoint.
    IMPORTANT:
    The ports in use cannot be modified with the exception of ports for "UDP-Payload".
${DocTitle}, ID: ${DocID}
© 03/2026 Mitel Networks Corporation. All rights reserved. Mitel and the Mitel logo are trademark(s) of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH & Co. KG. All other trademarks herein are the property of their respective owners.