2.12.11. TYPE SIGQOS - Quality Monitoring for the Signaling
Connection over IP 
Generation
 |
Configuration Management > System Data
> IPDA > Access point
Click Search and enter
or change the required parameters on the Quality of Service tab
in the Signaling Quality of Service section, then click Save.
|
 |
CHANGE-STMIB:MTYPE=NCUI2,LTU=99,TYPE=SIGQOS,
BANDW=40,MAXRTD=500,MINTHRPT=30, SIGPTHSW=EXTEND,QOSSTAT=NO; |
The setting becomes effective immediately.
IMPORTANT:
If the Bandwidth to the shelf is less than 64kbits/s
then BANDW should also be specified accordingly. If Signaling
Survivability is not installed then SIGPTHSW=STD should be used.