168
SCSU - Subscriber Configuration of Switching Unit
I
nterrelationships
P
arameter Description
Functions of the AMO
Error Messages and Advisories
AMO SCSU is used to configure ports for the connection of the following terminals:
•
ANATE to
SLMA, SLMA1, SLMA2, SLMA3, SLMA24, SLMAB, SLMAR, SLMAC
•
Charge Metering ANATE (ANATECM) to SLMAR
•
AUXDIGI to SLMB, SLMB4
T
he digital terminals at S0/Up0/UpoE such as SET600/OPTISET/OPTIP500 are set up using AMO
SBCSU
.
Special subscribers (e.g. Hicom Trading Board subscribers) are configured by AMO
SSCSU
.
Each STN number can be assigned personalized data such as names or personal identification numbers (PIN) using AMO
PERSI
.
A
M
O TGER is used to assign additional station numbers to non-voice terminals which have already been assigned a number (AMO SCSU/
SBCSU
).
It is also possible to configure "virtual" ports for all device types which have not been assigned to a module but are configured in the same way as regular physical ports. Virtual ports are identified as INS=FLOAT or INS=ACLSTN. These ports are used by any ID card user who identifies himself at
a
nother terminal by inserting his ID card or by keying in the PIN, and who then makes the call using the features of his virtual port such as classmarks, speed dialing digit series etc..An ANATECM is not allowed to be configured as virtual port.
If an AUXDIGI station is configured as "virtual" port, it is set to the READY state (in contrast to an ANATE).
It is also possible to install a signed off fictive station by depicting INS=SIGNOFF. A signed off station can
only
be
a
n ANATE
.
Signed off stations can be signed on
•
by entering a PIN-Number and a key number at the specific terminal or
•
by being signed on terminal by means of service staff
•
by administration command (AMO
DSSU
)
Signed off stations can be added to communication groups such as pick up groups, hunting groups etc. This allows a complete preconfiguration of subscribers.
For "virtual" ports (e.g. INS=FLOAT) PEN-specific parameters (e.g. COFIDX) are ignored.
A suffix-dialing connection is required for connecting special facilities such as VMX servers. This connection is identified as SPEC=SUFDIAL and parameterized using the parameter DHPAR.
F
or special stations (e.g. COMTEL) and for special country specific adaptions in SLMA1/
SLMA2/SLMA3/
SLMA24
/SLMAB/SLMAR/SLMAC
-Loadware paramet
e
rization can be done by using parameter DHPAR
.
Some special subscribers like Voice Pagers etc. are configured using parameter SPEC.
Secondary associated devices can be configured using parameter PRIMDEV. For more details, please check AMO
SBCSU
.
OpenScape 4000 V10, Volume 1: AMO Descriptions, Service Documentation, Issue 5
, ID:
P31003H31A0S107057620
©
09/2025
Mitel Networks Corporation. - All rights reserved.
Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG. All other trademarks herein are the property of their respective owners.