17.65. SDID - Deactivate partial digit analysis in the device
handler, activate single digit direct inward dialing 
Feature:
Activate/deactivate partial digit analysis in the device handler
Single digit direct inward dialing
Function:
If the SDID parameter is set in the COT of a trunk, then the partial digit analysis
set up
with the AMO TWABE for the preliminary analysis of digit sequences is not performed
during
incoming seizure in the device handler. The incoming digit sequences are not collected
in
the device handler. They are forwarded to call processing on a digit-by-digit basis.
On the other hand, if the SDID parameter is not set, then incoming digit sequences
are
forwarded via partial digit analysis in the device handler in the case of an incoming
seizure, so that the digits are pre-analyzed according to the TWABE administration
data and
are collected until the set number for the call number length is reached in the device
handler. This relieves actual partial digit analysis in call processing.
AMO Interrelationships:
TWABE Partial Digit Analysis
Device types:
Analog and networking trunks
For example, DP, SOCOD, S2COD, SOCONN, S2CONN, etc.
Protocol variants:
For example:
ANALOG - Protocols for analog trunks
CORNV33 - CorNet protocol
ECMAV1 - ECMA QSIG V1 protocol
ECMAV2 - CorNet-NQ Issue 1.2 Dec. 96 Basic ETSI
ECMAV2R - QSIG ETSI ETS 300 172 3rd. with SS 2nd.
PSS1V2 - CorNet-NQ Issue 2.1 Dec. 96 Basic ISO/IEC
PSS1V2R - QSIG ISO ISO/IEC 11572 2nd. with SS
EDSGER - EDSS1 protocol for Germany
ETSI - Standard EURO-ISDN
EDSS1NET - EDSS1 Net Side protocol