17.33. MFCL - Line with MFC (Multi-Frequency Code) signaling 
Feature:
MFC-R2 signaling/country connection technology
Function:
In the case of analog line trunks operated with MFC signaling, such trunks of the
MFCL
parameter are to be set in the seized trunk parameter classes. This applies to both
the
calling and called line side.
AMO Interrelationships:
COT Configure Parameter Classes:
|
TIEI
|
Identification of tie trunk circuit (MFC)
|
|
ATDI
|
Identification of attendant ATTND (MFC)
|
MFCTA Edit MFC Tables:
The MFCVAR parameter is used to seize an MFC table for a trunk
TACSU Configure Analog Trunks:
|
MFCVAR
|
.... MFC variant
|
IMPORTANT:
When setting up an MFC trunk, only a value greater than 0 can be
entered as the MFC variant. Otherwise error message F37 "If MFCVAR = 0, trunk parameter
MFCL
may not be entered (AMO COT)" is displayed. If the MFC variant = 0 (trunk is operated
with
dial pulsing) is assigned, trunk parameter MFCL should not be entered.
|
DIALTYPE
|
.... dialing type for incoming and outgoing traffic
|
IMPORTANT:
If MFC (multifrequency code) or DIPA (dial pulsing with ANI - automatic
number identification) is entered for the incoming and/or outgoing dialing type, then
a
value greater than 0 must be administered for MFCVAR.
Device types:
Analog trunks with MFC signaling, e.g. ICF, ICLLP, ICLFB, ICLIB