17.59. PINR - Signal PIN features network-wide 
Feature:
Network-wide PIN features (Personal Identification Number)
Function:
The parameter PINR is used to enable the signal messages for the PIN features, such
as "PIN
activation, PIN deactivation by mobile subscriber, PIN deactivation at home station,
activate/deactivate COS changeover and update PIN mail information" network-wide on
a
COT-dependent basis.
This parameter is checked along the nodes transited between the user and the destination
object, both in the case of incoming and outgoing digital tie trunk circuits. The
links
between the user and the destination object must be set up with LCR.
Connection setup to the destination object is rejected if the parameter is not set
at any
point among the relevant trunks in the network.
AMO Interrelationships:
IMPORTANT:
The parameter PINR must not be set in the
case of network links to Hicom 300 nodes lower than Hicom 300 E V1.0
or external systems which do not permit network-wide PIN signaling.
FEASU Features in the SWU:
|
PINNW
|
....
|
Enable PIN network-wide
|
ZAND Central System Data:
|
PIN
|
...
|
If a subscriber identifies himself at an external station and selects the server
from there, then, depending on the switch, the number of the home station or
external station is signaled to the server
|
Device types:
Digital interface circuits and tie trunk circuits
For example, SOCONN, S2CONN
Protocol variants:
For example
|
ECMA1R
|
ECMA QSIG V1 protocol
|
|
ECMAV2
|
CorNet-NQ Issue 2.1 Dec. 96 Basic ETSI
|
|
ECMAV2R
|
QSIG ETSI ETS 300 172 3rd. with SS 2nd.
|
|
PSS1V2
|
CorNet-NQ Issue 2.1 Dec. 96 Basic ISO/IEC
|
|
PSS1V2R
|
QSIG ISO ISO/IEC 11572 2nd. with SS
|