15.1.1. Default parameters for COP 
The following is a short excerpt from the COP parameters.
You can retrieve these at the system with
DISP-COP:SOURCE=HD;.DISP-COP:SOURCE=HD;
H500: AMO COP STARTED
COP: 1 INFO: 10: AMT IKZ O. ABWURF
DEVICE: DP SOURCE: HD
PARAMETER:
DUALTONE MULTIPLEFREQUENCY
DTMF
LINE WITH START-DIAL-SIGNAL
SDL
START-DIALING-SIGNAL TIMER 1 (AMO DTIM2: PARAMETER STADIAL1)
TIM1
PREDIALING DELAY 2 (AMO DTIM2: PDLY2)
PDP2
MAKE/BREAK RATIO FOR DTMF 3 (PULSE=200MS,PAUSE=200MS)
DTM3
CO TRUNK ACCESS:
TRUNK ACCESS
TA
TOLL ACCESS:
TRUNK ACCESS
TA
COP: 2 INFO: 11: AMT IKZ M. ABWURF
DEVICE: DP SOURCE: HD
PARAMETER:
DUALTONE MULTIPLEFREQUENCY
DTMF
LINE WITH START-DIAL-SIGNAL
SDL
START-DIALING-SIGNAL TIMER 1 (AMO DTIM2: PARAMETER STADIAL1)
TIM1
PREDIALING DELAY 2 (AMO DTIM2: PDLY2)
PDP2
MAKE/BREAK RATIO FOR DTMF 3 (PULSE=200MS,PAUSE=200MS)
DTM3
CO TRUNK ACCESS:
TRUNK ACCESS
TA
TOLL ACCESS:
TRUNK ACCESS
TA
COP: 3 INFO: 12: AMT HKZ
DEVICE: MOSIG SOURCE: HD
PARAMETER:
DUALTONE MULTIPLEFREQUENCY
DTMF
LINE WITH START-DIAL-SIGNAL
SDL
START-DIALING-SIGNAL TIMER 1 (AMO DTIM2: PARAMETER STADIAL1)
TIM1
PREDIALING DELAY 2 (AMO DTIM2: PDLY2)
PDP2
MAKE/BREAK RATIO FOR DTMF 3 (PULSE=200MS,PAUSE=200MS)
DTM3
CO TRUNK ACCESS:
TRUNK ACCESS
TA
TOLL ACCESS:
TRUNK ACCESS
TA
COP: 4 INFO: 20: S0/2 AMT EDSBRD O. ABWURF
DEVICE: S2COD SOURCE: HD
PARAMETER:
CO TRUNK ACCESS:
TRUNK ACCESS
TA
TOLL ACCESS:
TRUNK ACCESS
TA
COP: 5 INFO: 21: S0/2 AMT EDSBRD M. ABWURF
DEVICE: S2COD SOURCE: HD
PARAMETER:
CO TRUNK ACCESS:
TRUNK ACCESS
TA
TOLL ACCESS:
TRUNK ACCESS
TA
COP: 6 INFO: LEER / NOT USED
DEVICE: S2COD SOURCE: HD
PARAMETER:
NO PARAMETER VALUES ASSIGNED
and so on.