- DIMSU configuration for DIUS2 (all dimsu needed for
DIUS2)
ADD-DIMSU:TYPE=ADMCC, CCIDXS=2000;
ADD-DIMSU:TYPE=BASIC, LODEN=2000, PRI=20, TRK=100, SG=100, NWBCHL=600, CRCP=50, DPLNCD=800, ....;
ADD-DIMSU:TYPE=SYSTEM, PERMDL=100, ..;
- Configuration fo LTG, LTU and
DIUS2
ADD-UCSU:UNIT=LTG, LTG=1, SIPARTNO="Q2234-X ";
ADD-UCSU:UNIT=LTU, LTG=1, LTU=1, LTPARTNO="Q2248-X";
ADD-BCSU:MTYPE=PER, LTG=1, LTU=1, SLOT=67, PARTNO="Q6401-X", FCTID=2;
- Basic configuration of
LCR
ADD-WABE:CD=19, DAR=OWNNODE;
ADD-WABE:CD=16, DAR=TIE;
CHANGE-ZAND:TYPE=ALLDATA, NNO=100, NODECD=19;
ADD-COP:COPNO=5;
ADD-COT:COTNO=20;
ADD-BUEND:NO=30, TGRP=23, NAME="CDG-DPNSS1";
- Configuration of trunk (use a proper LCOSS and LCOSD to get the necerssary access
and
a node number
)
ADD-TDCSU:OPT=NEW, PEN=1-1-067-00, BCGR=1, CCT="CDG-DPNSS1",
COTNO=20, COPNO=5, LCOSV=1, LCOSD=1, PROTVAR=ECMAV2, DEV=S2CONN,
or S2COD ), TGRP=23, LWPAR=2; CHANGE-REFTA:TYPE=CIRCUIT, PEN=1-1-067-00, PRI=80;
OpenScape
4000 can accept the clock from DPNSS1 (depending on prio and error counters) And if
the circuit is configured through CDGM to retrieve the clock from
DPNSS/DASS
OR
OpenScape 4000 does not accept clock from DPNSS-Network but
delivers it (PRIO=0) (for details see also
Section 46.5.6, "Network Clock Supply").
OpenScape 4000 should always accept the clock from a DASS circuit and never deliver
it.
