- Setting up the digit analysis result for a routing code (AMO WABE NETRTE):
ADD-WABE:CD=20,DAR=NETRTE,CHECK=NO;
- Setting up a route with utilizable trunk groups to destination node 1-89-200,
with destination number 20 for voice connections (AMO RICHT):
ADD-RICHT:MODE=CD,LRTE=200,CD=20,CPS=0,SVC=SPVH,
NAME="TO NODE 200",TGRP1=20&30&40,DESTNO=20,DNNO=1-89-200,
PDNNO=2-89-200,ROUTOPT=YES;
- Define dial rule with AMO LODR (repeat digit sequence dialed on line):
ADD-LODR:ODR=1,CMD=NPI,NPI=UNKNOWN,TON=UNKNOWN;
ADD-LODR:ODR=1,CMD=ECHO,FIELD=1;
ADD-LODR:ODR=1,CMD=END;
ADD-LODR:ODR=1,INFO="CLOSED NUMBERING UNKNOWN";
- Set up primary route to route 200 with AMO LDAT (direct connection):
ADD-LDAT:LROUTE=200,LSVC=VCE,LVAL=1,TGRP=20,ODR=1,LAUTH=1,
CARRIER=9,ZONE=EMPTY,LATTR=NONE;
- Set up secondary route to route 200 with AMO LDAT (alternative connection
1):
ADD-LDAT:LROUTE=200,LSVC=VCE,LVAL=2,TGRP=30,ODR=1,LAUTH=10,
CARRIER=1,ZONE=EMPTY,LATTR=NONE;
- Set up alternative route to route 200 with AMO LDAT (alternative connection
2):
ADD-LDAT:LROUTE=200,LSVC=VCE,LVAL=3,TGRP=40,ODR=1,LAUTH=10,
CARRIER=1,ZONE=EMPTY,LATTR=NONE;
- Set up station numbers as digit analysis result STN (AMO WABE):
ADD-WABE:CD=7200&&7298,DAR=STN;
- Refer station numbers to the destination number (here: 20, i.e. Node 1-89-200):
CHANGE-WABE:CD=7200&&7298,DESTNO=20;
