5.18.3.14. Using the ITR (Internal Traffic Restriction Group) With MFC-R2 
The MFC table is modified for the special networks of Hungary. This
assigns an ITR to the Group II signal. Using the AMO VBZ, you can configure
the appropriate restrictions. You can use this feature everywhere that
you use MFC-R2. Because the ITR is transmitted in a OpenScape 4000/HiPath
4000 network, this feature is valid throughout the network.
Use the column "ADINFO" in the table TYPE=TBLB,OPT=FORIA (AMO MFCTA).
This column is initialized to 0 for each pending signal. This guarantees
that the new feature is normally not active. This value is also initialized
in the AMO TACSU to ITR.
Configuration example for assigning ITR 5 to signal II-5 (mediator):
CHANGE-MFCTA: MFCVAR=x, TYPE=TBLB, OPT=FORIA, PHYSIG=5, ADINFO=5;