Configure number conversion as follows:
ADD-RUFUM:TYPE=COMB,FAX1=number,FAX2=number; or
ADD-RUFUM:TYPE=COMB,DTE1=number,DTE2=number;
FAX1, DTE1 correspond to the combination codes (FAXNO,
DTENO) in digit analysis. FAX2, DTE2 correspond to the station numbers
of the devices in OpenScape 4000
IMPORTANT:
Conversion is not possible if the station numbers
are identical in the AMO RUFUM, for example, for the parameters FAX1
and FAX2. It is not necessary either because dialing the combination
code always sets up a connection to the device with the same station
number. All you have to do is set the station number 4711 to DAR=FAXNO
under CPS 6 in WABE and set 4711 to DAR=STN for the other CPSs. If the
fax device is configured under 4711, it is reached (even if number conversion
is not performed) by dialing 4711 in CPS 6 (exchange indial) under DAR=FAXNO.
