10.2.14.2. Changing the Address of the Survivability Network 
This case scenario, while unlikely, is simple to realize in the OpenScape
4000 switch. All addresses in the survivability network are fixed addresses
derived from the network address.
 |
Configuration Management > System Data
> IPDA > IPDA System Data
Click Search, change
the survivability network address on the System Data tab and Save.
Configuration
Management > System Data > IPDA > IPDA System Data
Click
Search and select the access point.
Click Execute
on the Action pull-down menu and select the mode of action Update
AP, confirm with OK.
|
 |
CHANGE-SIPCO:TYPE=LSNET,SURVNET=192.168.123.0;The
change within the access points becomes effective after
EXEC-USSU:MODE=UPDATAP,LTU=xx;
for all affected access points.
|
IMPORTANT:
Connections are cleared down without further
warning. Prior to the
EXEC-USSU:UPDATAP, the configuration
must be updated on the system hard disk. IMPORTANT:
As ports of the survivability router are also
affected by the address change, the routers also have to be reconfigured. However,
this may not be performed until after conversion of the access points.