125.3 Interrelationships

 
•
AMO ACSU
:
Parameter NNO: Assigns (fictitious) originating node numbers to attendant consoles
Assignment of a display suppression attribute to attendant console (SATNDNO=ONLYEXT)
•
AMO COT
:
Parameter PAR: The values LWNC, DFNN are assigned for trunk circuits which do not transmit usable originating node codes incoming / outgoing.
•
AMO DIMSU
:
Parameter RSTCON: Sets the number of originating nodes from which connections are to be restricted.
 
:
Parameter DSPMOD and DPDSPMOD: Sets the number of originating/destination node combinations for which station number modification is to be set.
•
AMO KNDEF
:
Definition of the virtual nodes within the own physical node (TYPE=OWN, parameter NNO)
Per virtual node the node codes and the skip digits for the node codes for the numbering plan UNKNOWN are configurable (parameters NODECD and NODECDSK)
•
AMO KNFOR
:
Sets the node format table
•
AMO KNPRE
:
Sets the node prefix table
•
AMO LDAT
:
Parameter DNNO: Assigns an individual virtual destination node number for each routing element
•
AMO LODR NPI / TON
:
Branch CMD=NPI: Assigns NPI and TON in the outdial rule
•
AMO RICHT
:
Parameter DNNO: Assigns the individual virtual destination node number (not a transit node number) for each route
•
AMO SDAT
 
Change the virtual node number of a station and regenerate it
Change the display suppression attribute (SSTNO= ONLYEXT)
•
AMO SBCSU
AMO SCSU
AMO SSCSU
 
Assignment of a default virtual node number (taken from KNDEF-Table) to a subscriber when configuring a new station (not visible at user interface). For display and regenerate action AMO SDAT has to be used.
Assignment of a display suppression attribute (SSTNO=ONLYEXT)
•
AMO TACSU
:
Parameter NNO: Assigns (fictitious) originating node numbers for incoming trunk circuits which do not transmit an ONNO (e.g. trunk circuits)
•
AMO TDCSU
:
Parameter NNO: Assigns (fictitious) originating node numbers for incoming trunk circuits which do not transmit an ONNO (e.g. trunk circuits)
Parameter ISDNxx, PNPxx: Configuration of prefixes for digital trunk circuits if KNPRE prefixes cannot be used
•
AMO TSCSU
:
Parameter NNO: Assigns (fictitious) originating node numbers for special equipment and special networks
•
AMO WABE
:
Branch TYPE=DNNO, parameter DNNO: Displays destination nodes and destination system numbers
Parameter DAR=OWNNODE: Assigns own node codes
${DocTitle}, ID: ${DocID}
 © 02/2025 Mitel Networks Corporation. -  All rights reserved.
 Mitel and the Mitel logo are trademarks of Mitel Networks Corporation. Unify and associated marks are trademarks of Unify Software and Solutions GmbH&Co. KG.
 All other trademarks herein are the property of their respective owners.