|
Board Configuration, Switching Unit
The AMO BCSU configures the following modules: DIU-N2, DIU-N4, DIU-S2, SLC24, SLMO, SLOP2, SLMQ, SLMQ3, SLMS, STHC, STHC2, STMA, STMD, STMD2, STMI-HFA, STMI2-HFA and WAML2 |
||||
|
Class-of-Service, Switching Unit
The AMO COSSU creates classes-of-service, which can be assigned to a station line circuit with the parameters COS1 and COS2. The same AMO can be used to create the LCR classes-of-service (for services VOICE and DTE), which can be assigned to a subscriber line with parameters LCOSV1 and LCOSV2 or LCOSD1 and LCOSD2. |
||||
|
Dimensioning of Features, Switching Unit
The AMO DIMSU administers the database layout for device memories and additional memories required by the call processing system and the device handler. |
||||
|
Device Switch of Switching Unit
The AMO DSSU can be used to put an S0 bus and its terminals into service or to block it. |
||||
|
||||
|
Station Configuration of Switching Unit
The AMO SCSU is used to assign virtual stations for associated terminal adapters |
||||
|
Special Subscriber Configuration of Switching Unit
AMO SSCSU configures the terminals additionally required for the remote user |
||||
|
System Data
The AMO ZAND is used to define terminal pre-settings valid for new OPTISET / OPTIP500 / OPTIIP terminal devices to be configured. The AMO ZAND also loads the option table(s) relevant to the functional terminal devices from Hard Disk and allows their subsequent modification. |
||||
|
System Data
AMO ZANDE is used to configure the used CMI version. |
||||